+55 (16) 3371-0112 •

Metrolog SIAD S270912D software

Image SIAD S270912D

Metrolog SIAD S270912D software was designed to acquire and process dimensional data from DC Motor commutators.

The software uses an SD20-LVDT signal conditioner and an LVDT sensor to scan the surface of the commutator, being able to detect and measure its diameter, gaps heights, gaps unevenness and global runout error. Embedded data processing and analytics are able to automatically segment gaps, remove surface roughness noise and compare the results to pre-defined tolerance levels. The easy to sight approval/reproval indication allows use in production lines for quick quality inspection.


Features

  • Allow easy integration on most measurement fixtures
  • Flexible software parametrization
  • Detection of individual segments and dimensional relationships between them
  • Segment edge detection and removal
  • Visual roughness indication
  • Outside diameter and runout measurements
  • Additional features can be added to the software, based on the application requirements
  • Low cost of ownership
  • Windows system compatible
  • Simple measurement hardware (SD20-LVDT and an LVDT sensor)
  • Only one USB 2.0 port required

Typical integration

The SIAD S270912D connects to a Metrolog SD20-LVDT signal conditioner acquire data for processing. It also uses the SD20-LVDT digital output port to signal the motor driver to start and stop. Optionally the SD20-LVDT input ports can be connected to push buttons for easy software use.

 

SIAD S270912D typical integration

 


Video and screenshots

Software demonstration (data acquisition and processing show in real time).

 

Data acquisition and analysis of an 8 segment DC motor commutator.

8 segment commutator

 

Data acquisition and analysis of a 12 segment DC motor commutator.

12 segment commutator

 

Data acquisition and analysis of a 16 segment DC motor commutator.

16 segment commutator