LVDT Schaevitz® Transducers - GC-485 Series
GC-485 DigiSense™ Gage Head is available in five bipolar measurement ranges, with standard strokes from ± .050 inches to ± 1.0 inch. The single ended 8.5 to 30.0 volt dc. input and two-wire, addressable RS-485 output, make the GC-485 ideally suited to factory automation applications. Direct digital output eliminates the need for expensive and error prone analog to digital conversion. The sensor signal is scaled into calibrated engineering units, by the internal microprocessor, using factory computed conversion tables, thus providing a traceable measurement without need of an on-site calibration. A certificate of calibration is shipped with every sensor. |
|
Available models
- Available measurement range: ±1.27 mm, ±3.17 mm, ±6.85 mm, ±12.70 mm and ±25.40 mm
- Package: plain (19.05 mm diameter)
Features
- 0.05% Linearity
- Up To 32 Sensors On One 2-Wire Network
- 100% Interchangeability
Without Calibration
- Hermetically Sealed Design
- MOD-Bus ASCII & RTU Output
- Factory Calibrated English or
Metric Output
- Programmable Filtering
Velocity Output
- Built-in Tare & Un-Tare
- Built-in Min, Max & TIR
- Velocity Output
Applications
- Roller Gap Control
- In-Process Wet Grinding
- Hand Held Gages
- X-Y Positional Feedback