Laser diode UD Series
Diode lasers of LAP UD Series are designed for installation low above the working surface. The UD series was the answer on customers requests for a laser with small housing like LD series, line length and quality of UltraLine to be built in low above working level. |
|
The main target for UD lasers are veneer or sheet metal shears, as well as any place where you have little headroom but you need a long line, starting directly below the laser. You need a 4 m line, you only have 50 cm of height and the laser must be installed on one side of the opening ? Then you need a UD laser!
The laser line starts directly below the laser, caused by a cylindrical lens and the beam outlet 45 to mounting direction. The beam has a constant brightness over most of the line length. Laser with beam outlet in mounting direction or 90 to it have to be fixed high above the center of your working table, UD-lasers may be attached low on left- or righthand side.
Features
- Smallest housing
- For extremely low mounting positions
- Special optics for line of virtually constant brightness
- Line brightness at the end of the UD line is 2,5 × higher than of a diode laser with classic optic design and similar power
- 5 V power supply
- 5 - 30 mW laser output
Models and Laser Class
| Output power |
Line laser | Line length * | Laser class |
| 5 mW | LAP UD-PL | up to 3 m | 2M |
| 10 mW | LAP UD-XL | up to 6 m | 2M |
| 15 mW | LAP UD-XXL | up to 9 m | 2M |
| 30 mW | LAP UD-XXXL | up to 12 m | 3R |
* depends on ambient light, height above surface, angle
General Data
Laser type, wavelength |
Diode, 635 nm, red |
Divergence |
0,5 mrad |
Power supply |
4 - 6 VDC |
Power consumption |
< 200 mA |
Ambient conditions |
-10 ... +40 C, 35 - 90 % rel. humidity, non condensing |
Dimensions |
Length 70 mm × Ø 23 mm (front) / 15 mm (back) |
Enclosure rating |
IP 42 |
Accessories
B2-LD |
|
B3-LD |
|
B2-KIPP |
|
BKK with B2-LD |
|
Power Supply |
|
